Drive PainAwayPro With Heat Manual De Instrucciones página 16

There are totally 8 preset stimulation modes.
Press the "M" button to select a desired pulse
mode. The mode selected will be shown on the
display.
th
6 Step - Choose the stimulation time
The default timer is 30 min, and pressing the "T"
button could select a desired timer (30, 40, 50, 60,
10, and 20 min). The timer selected will be shown
on the display.
th
7 Step - Adjust the stimulation intensity
Pressing the "+" button could increase the
intensity, while pressing the "-" button could
decrease the intensity. The intensity change will
be reflected on the display.
Note: With the increase of intensity (total of 20
levels), you may experience sensations like
tingling, vibration, pain, etc. Therefore, gradually
increase the intensity, and stop increasing when a
comfortable level is reached.
th
8 Step – Use heat/temperature on the device
Press the "Heat +/-" button for the first time to turn
on the heat Level 1 of up to 104
time to adjust to Level 2 of up to 109.4
the third time to turn off the heat. The heat will be
reflected on the display.
Note: The device is used for the electrical
stimulation or heat; consult with your physician
before using electrical stimulation and heat
simultaneously.
th
9 Step - Hold the "ON/OFF" again to turn off
the power after done
When the countdown timer is up, the device will
turn off automatically. The device could be also
turned off by holding the On/Off button, indicated
by the display light off.
o
F, for the second
o F and for
14