Test Strip - ForaCare D20 No-Coding Manual Del Usuario

Test Strip

Front Back
The front side of the
test strip should face
up when inserting
the test strip.
The ForaCare D20 No-Coding monitor should only be used with FORA D20
Test Strips. Using other test strips with this meter can produce inaccurate
results.
ATTENTION:
Test results might be wrong if the contact bar
is not fully inserted into the test slot.
NOTE
Absorbent Hole
1
Apply a drop of blood here.
The blood will be
automatically absorbed.
Confirmation Window
2
This is where you confirm if
enough blood has been
applied to the absorbent
hole in the strip.
Test Strip Handle
3
Hold this part to insert the
test strip into the slot.
Contact Bars
4
Insert this end of the test
strip into the meter. Push
it in firmly until it will go no
further.
11