JMA CTM-700 Manual De Instrucciones página 15

pressing the first button of the original control,
the second button of the original control and
the entry buttons of the original control. This
last one can be found behind the controls or
behind a small orifice under the battery cover.
Normally, when the first button is pressed,
the first digit will be 2, 1 or 4.
PUSH BUTTON TABLE
Table Control type
No.
0 JCM 1ª NORTON, ROPER,
1 NICE SMILO, GIBIDI
2 MUTANCODE
3 ERREKA, BFT,DEA
4 LIBRE
5 PUJOL
6 CELINSA
7 DOORMATIC
8 LIBRE
9 LIBRE
Look for the desired combination of the ori-
ginal control and select this option.
In the next step, an automatic or manual
copy method may be selected. Using the
automatic mode, assign the desired serial
number. If the manual method is used, it will
indicate that a number needs to be entered.
This value will be the number of positions
over and above the original serial number
we wish to assign. If it is left as 0000, an
exact "clone" of the same serial number of
the original control will be attained.
Lastly, In some controls such as Erreka or BFT
a second transmission can be requested using
the P3 push button (the entries push button
which can be found in the part behind the
control or in the battery housing).
Connect the cable marked EM-ROLL to the
When the second button is pressed, the first
digit will be 4, 6, 8 or 2.
When the entry button is pressed, it could
be F, E, 9 or 8.
The following table shows the different
configurations of push buttons that can be
programmed:
Lower push Upper push
button key button key
2
2
2
2
2
2
4
1
2
2
machine and to the destination emitter and
press 'Enter OK' to accept.
IMPORTANT!
CONTROL TO COPY ANYTHING BEFORE THE
MACHINE HAS REQUESTED IT AND IN THE
POSITION SHOWN.
If 'Copy Correct' appears, the process has
satisfactorily completed.
In the case that the message 'Copy Error'
appears, repeat the process by analysing the
original emitter again.
Rear push
button key
6 E
4 9
4 8
4 F
4 6
4 E
6 2
8 7
C E
8 E
DO NOT CONNECT THE
15 15