Descargar Imprimir esta página

CBX WOYA Manual Del Usuario página 10

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 20
EN
Open and installing
Open the frame: Release the folding lock at side of frame, hold the handle bar and pull the frame
1
upwards, until you hear a ‚click' , then it is locked in position.
NOTE: Ensure that the frame has been opened before use.
Rear wheels installation: Align the rear wheel mount with spring pin on the rear bracket, then in-
2
sert it until you hear a ‚click' and the pins pop up. Depress the pins and then directly pull them out.
Front wheels installations: Insert the axle of front wheel assembly into the hole until it 'clicks' .
3
Depress the dismounting button and pull out to detach front wheels.
Tray: Set tray disk into the tray socket at the same time. When there is a „Click", the tray will be
4
settled. Pull out the tray with your both hands at the same time, then it will be dismantled.
Using
Swivel Lock: As shown in picture, pull up the swivel lock buttons on both sides, then the stroller
5
can go in a straight line. Push down swivel lock buttons on both sides, then the wheels can go
freely in any directions.
Rear brake: As fig 2, Step down on either left or right brake pedal to set the brake, and lift it up
6
to release.
Backrest adjustment: To raise seat, hold the pull tab of backrest with one hand, depress the
7
adjust lock and push forward with another hand, then backrest can be adjusted to a more upright
position. To recline seat, depress the adjust lock and take the pull tab backward.
8
Leg rest: Depress the adjust buttons on both sides to adjust leg rest.
9
Adjust canopy: Pull or push the canopy strip front per picture, the canopy can be adjusted.
Harness system
Release: press the two buttons in the middle to release.
10
Fasten: insert 2 clips into the socket until "clicks".
Harness adjustment
Shorten: draw out top zone, then draw out tail belt, lock it.
Elongate: draw out top zone, then shorten tail belt, then lock it.
Basket installation: Align the basket's tube mount with pin on the seat tube, then insert it until
11
you hear a ‚click' and the pin pops up. At the end bypass the basket before buckling around on both
sides of the support bar on either side of the cloth inside, button on the buckle.
Folding
Step 1 Close the canopy first.
12
Step 2 adjust backrest at the lowest position.
Step 3 lift up the two fold straps under the pocket in the seating area at the same time as shown
until the folding hook closes up. Self-standing after folding.
10
INSTRUCTIONS

Publicidad

loading