Problems And Solutions - DVA GIX Serie Manual De Instrucciones

GIX
instruction
manual
ning, check that the cable connecting the motor and the timer
hasn't slipped out (fig. 6, H), and that the optical sensor is the
right place (fig. 6, E).

14) PROBLEMS AND SOLUTIONS

PROBLEMS
The water softener does not regenerate
automatically
The water softener regenerates
at the wrong time
Water from the brine is not sucked,
the water softener does not consume salt
The brine overfills
Water softener salt consumption is
higher or lower than expected
After regeneration, water is not softened
Instruction Manual GIX CRONOMETER
CRONOMETER
SOLUTIONS
- make sure that the equipment is connected to power supply (fig. 6, G)
- check the settings (see chapter 5)
- check the current time and regeneration time settings
(vedi cap. 5.3 e 5.4)
- make sure that the water system pressure is at least 2 bar
- check that the drain pipe is not blocked and does not have too narrow
elbows that flattening the pipe (fig. 4, A)
- clean the injector (fig. 6, B) (see par. 9.1, "PERIODIC MAINTENANCE")
- make sure that there is no air intake where there are the quick joints (fig. 6, A)
- make sure the drain pipe is not blocked and does not have too narrow
elbows flattening the pipe (fig. 4, A)
- make sure that there is no air intake where there are the quick joints (fig. 6, A)
- clean the injector (fig. 6, B) (see par. 9.1, "PERIODIC MAINTENANCE")
- make sure the working pressure is at least 2 bar
- check that the "salt amount" value (see par. 5.6)
- check that the "salt amount" value (see chapter 5.6)
- check the settings (see par.par.5.5 e 5.6)
- check the power supply and the valve settings
- check that there is salt in the brine tank (fig. 7)
- check that the mixer screw is tightened correctly (fig. 2, B)
ENGLISH
19