Schwinn Fitness 460 Instrucciones Para El Montaje página 7

Step 2: Front Stabilizer
Parts
• Assembly from Step 1
• #3 - Front Stabilizer (Qty 1)
Hardware
• #24 - M8 x 20 Button Head Bolt (Qty 2)
• #26 - M10 x 80 Button Head Bolt (Qty 2)
• #27 - M8 Spring Lock Washer (Qty 2)
• #28 - M8 Flat Washer (Qty 2)
• #30 - M10 Spring Lock Washer (Qty 2)
• #31 - M10 Wide Flat Washer (Qty 4)
• #32 - M10 Hex Lock Nut (Qty 2)
Tools
• 6mm Hex Key
• Combination Wrench (or 17mm socket wrench - not
included)
Assembly
Note: This step requires two people.
2-1 Have one person lift the front of the Main Assembly
while the second person slides the Front Stabilizer
under the Main Assembly bracket with the wheels
facing away from the Main Assembly.
2-2 Seat the Main Assembly bracket on the Front
Stabilizer and align the bolt holes.
Note: If you have difficulty seating the Main Assembly
onto the Front Stabilizer, lift the Rear Stabilizer a few
inches off of the floor until the bolt holes line up.
2-3 Install two M8 x 20 Button Head Bolts (#24), two M8
Spring Lock Washers (#27) and two M8 Flat Washers
(#28) through the top bolt holes.
2-4 Install two M10 x 80 Button Head Bolts (#26) into the front
bolt holes with two M10 Spring Lock Washers (#30), four
M10 Wide Flat Washers (#31) and two M10 Hex Lock Nuts
(#32) as shown.
2-5 Tighten the hardware.
31
32
Figure 2
5
Assembly Manual
24
27
28
26
30
31
3