Warner Stride Lite Manual De Ensamblaje Y Instrucciones página 4

Adjusting Heel Cup
1. Place shoe in Heel Cup to determine if adjustment is
necessary. Your leg should be aligned with the Upper Side
Pole. If it is not aligned, you will need to adjust as follows.
2. Loosen Heel Cup fasteners and place shoe in Heel Cup
again.
3. Slide Heel Cup in or out to adjust length of Foot Plate so your
leg is aligned with the Upper Side Pole. Incorrect Heel Cup
adjustment can result in improper leg support and instability.
4. Make sure nuts are fastened securely.
Adjusting Height of Leg Support Cuff
1. Stand or sit in a comfortable position to try on the
assembled stilt.
2. Place appropriate shoe (i.e., left or right) in Heel Cup. Upper
Side Pole should be on outside of leg.
3. Position Leg Support Cuff on or above the calf muscle, below
the knee joint. Make sure the knee can flex properly.
4. Adjust the Upper Side Pole height by pulling up or
pushing down.
5. Remove stilt and tighten Upper Side Pole Clamp Bolt to
secure height. Do not over-tighten; a crushed Side Pole
may crack and break. Make sure the pole does not twist
during use.
Sideways Adjustment
1. Loosen Upper Side Pole Bracket bolt. This adjusts distance
between Foot Plate and Upper Side Pole.
2. While sitting, put stilt on.
3. Push or pull Side Pole so that knee is aligned over foot,
making sure leg is straight (i.e., knees not turned out).
4. Tighten the Upper Side Pole Bracket bolt.
4