Height Adjustment - Warner Stride Lite Manual De Ensamblaje Y Instrucciones

WARNING: It is important to adjust the stilts to feel comfortable.
Improper adjustment may cause fatigue and injury. If you feel
any pain or discomfort, re-adjust the fit.

Height Adjustment

1. Always remove stilts before adjusting the height.
2. Remove Height Adjustment Wing Bolts and pull Upper Legs
to required length.
3. Align the Wing Bolt holes, install the Wing Bolts and fasten
securely. Make sure lock washers are on before tightening
Wing Bolts.
4. Verify that front and back legs – and both stilts – are adjusted
to same height.
WARNING: Check to make sure Wing Bolts are tight before
each use.
Daily Cleaning and Inspection
WARNING: Inspect stilts daily and replace any worn or
damaged components immediately before use. Check for
excess wear and verify that all fasteners are tight.
1. Clean Foot Plates and Floor Plates before each use. Replace
your Floor Pads regularly to maintain maximum traction.
2. Clean and lubricate moving parts daily with a dry lubricant
like Silicone Spray. Be careful not to get lubricant on your
Floor Pads.
3. Check Nylon Sleeves to make sure the legs slide properly
with even pressure. To replace Sleeves carefully follow
instructions included with the Nylon Bushing Kit.
Parts needing inspection and routine replacement include:
Straps, Springs, Plates, Floor Pads, Legs, Leg Connections,
Leg Support Cuffs, Brackets, Clamps, Screws, Bolts, Nuts,
Rivets and Nylon Sleeves.
Storage
Store stilts in a dry location where they will not be bent or
damaged. Use straps to secure stilts together for easy transport.
7