Zanussi ZWH 5105 Manual De Uso página 35

You can also press the RESET (ANULAR) button to
exclude one or several phases of the programme
which is running, as indicated below:
- set the washing machine to PAUSE by pressing the
START/PAUSE button (the relevant light will flash);
- press the RESET (ANULAR) button once or several
times, until the required phase(s) is(are) cancelled
(the light next to the phase(s) will go out).
Example:
PREWASH
PRELAVADO
WASH
LAVADO
RINSES
ACLARADOS
SPIN
CENTRIFUGADO
DRAIN
DESCARGA
This button allows you also to select special
programmes, such as RINSES, SPIN and DRAIN.
• If the machine is already switched on because it
has just performed a washing programme, proceed
as follows:
- depress RESET (ANULAR) once or repeatedly to
cancel the previously performed programme (three
blinking dashes will appear on the display);
- select the type of fabric by means of button
TEJIDOS;
- select the special programme:
• RINSES
Depress RESET (ANULAR) once, the pilot light
WASH goes out.
• SPIN
Depress RESET (ANULAR) twice, the pilot lights
WASH and RINSES
• DRAIN
Depress RESET (ANULAR) three times, the
pilot lights WASH , RINSES
go out. The only DRAIN
remain lit.
Example:
PREWASH
PRELAVADO
WASH
LAVADO
RINSES
ACLARADOS
SPIN
CENTRIFUGADO
DRAIN
DESCARGA
• If the machine is switched off:
- depress ON/OFF button to switch it on;
- select the type of fabric by means of button
TEJIDOS:
In this case, the spin
(at the speed provided
for the selected type of
fabric) will be
performed.
go out.
and SPIN
pilot light will
In this case the
machine will perform
the rinses and spin.
35
- select the special programme as previously
described.
11 DELAY (INICIO DIFERIDO) button
This button makes it possible to delay the starting of
the programme from 30 - 60 - 90 minutes, 2 hours
and then by 1 hour up to 23 hours. The delay you
have selected is shown on the display for about 3
seconds; afterwards, the duration of the programme
reappears.
If the SOAK button has been pressed the selected
delay will correspond to the soak time (up to a max
of 10 hours). If no delay time is selected the SOAK
programme will last about 30 minutes.
You must select this option after you have set the
programme and before you press the
START/PAUSE button.
The time value shown on the display will decrease
by one unit every hour.
You can change the delay time at any moment,
before you press the START/PAUSE button.
If you have already pressed the START/PAUSE
button, and you wish to cancel the delay time,
proceed as follows:
• set the washing machine to PAUSE by pressing the
START/PAUSE button;
• press twice the DELAY button until the display
o'
shows and then press the START/PAUSE again.
To change the delay time, after the programme had
started, you have to set the programme again.
Important!
The door will be locked throughout the delay time
(DOOR LOCKED light lit).
If you need to open the door, you must first set the
washing machine to PAUSE by pressing the
START/PAUSE button. After you have closed the
door, press the START/PAUSE button again.
12 Programme phase indicator lights
When you select a programme, the lights relevant to
the phases that form the programme light up.
PREWASH
WASH
RINSES
SPIN
DRAIN
After you have started the programme, only the light
relevant to the phase that is currently being carried
out will remain lit.