they break.
Always check to make sure the area
where screws are being driven or
where holes are being drilled does
not have any hidden wiring. Contact
with a "live" wire will make exposed
metal parts of the tool "live" and
could result in an electric shock to
the operator.
Do not drive screws or break into
existing walls or other blind areas
where electrical wiring may exist. If
this situation is unavoidable, remove
all fuses or disconnect all breakers
feeding the work area.
Secure the workpiece in a vice or
with clamps. Never hold it in your
hand or across your legs. The
rotating action of the driver may
cause the bit to come loose from the
screw and cause injury.
Never carry the cordless driver with
your finger on the switch. The tool
is always in an "ON" condition when
the battery is charged.
Never hold the body of the cordless
driver
near
changing bits. Accidentally touching
the switch may start the tool and
possibly cause an injury.
Always use the correct shape of
screwdriver bit that matches the
head of the screw.
Always
use
the
switch
while
the
largest
screwdriver bit that will properly fit
into the head of the screw.
Do not use worn or damaged
screwdriver bits. Worn or damaged
screwdriver bits will not drive the
screw properly and may jump out
of the screw head, causing possible
injury and damage to the workpiece.
BATTERY
SAFETY
WARNING: Only use the charger
supplied with this kit to charge the
battery. Charging any other batteries
may damage the charger and possibly
cause serious injury.
The battery pack for this driver is
contained within the main housing
of the tool. Never attempt to open
the battery housing for any reason.
If the battery housing breaks or
cracks, immediately discontinue use
and do not recharge.
Do not charge the battery if the
battery housing is wet or shows any
evidence of corrosion.
A small leakage from the battery
may occur under extreme usage,
charging or temperature conditions.
This does not indicate a failure.
However, if the outer seal is broken
and this leakage gets on your skin,
follow these steps:
size
AND
CHARGER
6