Special Safety Instructions - Promaker PRO-TI20 Manual Del Usuario

e) Under abusive conditions,
liquid may be ejected from the
battery; avoid contact. If contact
accidentally occurs, flush with water.
If liquid contacts eyes, additionally
seek medical help. Liquid ejected
from the battery may cause irritation
or burns.
6) Service
Have your power tool serviced
by qualified repair person using
only identical replacement parts.
This will ensure that the safety of the
power tool is maintained.

SPECIAL SAFETY INSTRUCTIONS

1) Use auxiliary handle(s), if
supplied with the tool. Loss of
control can cause personal injury.
2) Hold power tool by insulated
gripping surfaces,
performing an operation where
the fastener may contact hidden
wiring. Fasteners con tacting a "live"
wire may make exposed metal parts
of the power tool "live" and could
give the operator an electric shock.
3) If possible, always use clamps or a
vice to hold your work.
4) Always switch off before you put
the tool down.
5) Ensure that the lighting is
adequate.
6) Do not put pressure on the tool, such
that it slows the motor down. Allow
the bi t to screw without pressure. You
will get better results and you will be
taking better care of your tool.
7) Keep the area free of tripping
hazards.
8) Only use accessory bits in good
condition.
9) Before starting, check that there is
sufficient clearance for the bit under
the work-piece.
10) Do not touch the bit after
operation. It will be very hot.
11) Keep your hands away from
under the work-piece.
12) Never use your hands to remove
dust, chips or waste close by the bit.
13) Rags, cloths, cord, string and the
like should never be left around the
work area.
when
14) Support the work properly.
15) If you are interrupted when
operating the tool, complete the
process and switch off before looking
up.
16) Periodically check that all nuts,
bolts and other fixings are properly
tightened.
17) When using the tool, use safety
equipment including safety glasses
or shield, hearing protection, and
protective clothing including safety
gloves. Wear a dust mask if the
operation creates dust.
6