Operations - Bissell 1887 Serie Manual Del Usuario

Operations

Machine prep
1. Remove the tank from the base of the
machine by lifting the tank carry handle.
2. Carry like a bucket to the sink. Pull upward
on bottom edge of the latch in the back of the
tank to unhook and remove the lid.
3. Pull up on the bladder fill cover that says
"Fill Here". Fill the bladder with clean hot
tap water (140°F/60°C MAX). *Do not boil or
microwave water as it can destroy the bladder.
4. Using the provided measuring cup, fill to
the indicated fill line on the measuring cup (2.5 fl
oz) and pour in to the bladder.
5. Replace the tank lid by seating the front
edge of the tank before the back, then lock
the latch in place.
NOTE: Remember to secure the lid and test
to make sure it is secure before picking up
the tank.
6. Place tank into machine base, seating
firmly in place.
Carpet cleaning
1. Plug the deep cleaner into a proper outlet. Set
ReadyTools dial to the Floor Cleaning setting.
Turn the power on by pressing the red power
switch on the back of the unit with your foot.
2. With your foot, press the gray handle release
lever located on the back of unit below water
tank to detent handle.
3. While pressing the spray trigger, make one
slow forward wet pass and another back. Let the
BISSELL deep cleaning formula, and DirtLifter
PowerBrush do the work for you.
Caution: Do not overwet.
4. Release the spray trigger and make one
slow forward and backward pass over the
same area to remove any residual dirty water
and aid in drying.
5. Repeat cleaning passes until solution being
suctioned up appears clean. Continue passes
without pressing the trigger until you can't see
any more water being suctioned up.
1
3
6
Tip
» Thorough vacuuming before
deep cleaning wll prevent early
clogging of the lint screen.
Power Switch
www.BISSELL.com
2
5
Handle Release/
Recline Pedal
7