Logitech 8701 Manual De Instrucciones página 4

Pairing your Headset with your Bluetooth
Your Logitech
will function. The following section describes how to pair your Logitech Mobile Bluetooth™
headset to a typical Bluetooth phone.
1. Charge your Mobile Bluetooth™ Headset using the charger/carrying case. Make sure the
headset is fully charged before proceeding (see page 4 for instructions on charging your
headset). Ensure the headset is turned off.
2. Press and hold down the Multi-function button for approximately 7 seconds until the
headset indicator light flashes blue and red.
3. While the light is flashing blue and red, release the button. The indicator light will
continue flashing for 120 seconds, indicating that the headset is in pairing mode and
waiting to communicate with another Bluetooth device.
4. Follow the operating instructions for your Bluetooth phone to start the pairing process.
Typically, this is done by going to a 'setup' or 'connect' menu and then selecting the
options to 'discover' Bluetooth devices. Bluetooth may take several seconds to establish a
connection.
5. Your phone's display should indicate to you that it found the 'Logitech HS01' headset
and ask if you want to pair it. You should confirm this.
6. The phone's display should then prompt you for a passkey or PIN. Enter a sequence of:
0000.
7. The headset indicator light will flash blue every 3 seconds, indicating successful pairing.
Usually the phone will also indicate if pairing was successful.
8. Your phone's display may also ask whether you want to change the headset's name. We
recommend that you approve the 'Logitech HS01' name and not change it.
9. If pairing does not occur as expected, turn the headset and phone off and wait 10
seconds. Turn the headset and phone on again and repeat steps 2-8.
2
English
® Mobile Bluetooth™ Headset must be "paired" to a Bluetooth phone before it
™ Mobile Phone