Loading Label Roll In Peel Off Mode; Loading Label Roll In Passing Mode - Carl Valentin SPE Instrucciones Abreviadas Y Recomendaciones De Seguridad

SPE

Loading label roll in peel off mode

Loading label roll in passing mode

92

Open the print module cover.

Open printhead (A) by turning the red pressure lever (B)
anticlockwise.

Open the engine support (C) by pulling the red bolt to the top.

Lead the label material (minimum height = 15 mm) below the label
guiding (D) and printhead (A) and take care that the labels run
through the photocell (E).

Press the engine support (C) again to the bottom until it locks.

In order to move the printhead (A) down, turn the red pressure lever
(B) in clockwise direction until it locks.

Adjust the adjusting rings (F) of the label guiding to the width of
material.

Lift the dispensing whip (G) by pulling the knurled knob (I) outwards
to the bottom.

Strip some labels from the backing paper and lead the backing
material over the dispensing whip (I) and between the plastic roll (J)
and the dispensing whip-shaft (G).

Press again the dispensing whip (G) to the top and lock it.

Lead the supporting paper to the back and fix it at a rewinding unit.

Enter the offset value in the 'Dispenser I/O' menu.

Close the print module cover.

Open the print module cover.

Open printhead (A) by turning the red pressure lever (B)
anticlockwise.

Open engine support (C) by pulling the red bolt to the top.

Lead the label material below the label guiding (D) and take care
that the label runs through the photocell (E).

Press the engine support (C) again downwards until it locks.

In order to move the printhead (A) down, turn the red pressure lever
(B) in clockwise direction until it locks.

Adjust the adjusting rings (F) of the label guiding to the width of
material.

Close the print module cover.
English