Change Engine Oil - Generac iQ3500 Manual Del Propietário

.
10W-30
Synthetic 5W-30
Inspect Engine Oil Level
Risk of burns. Allow engine to cool before
draining oil or coolant. Failure to do so could
result in death or serious injury.
Inspect engine oil level prior to each use, or
every 8 hours of operation.
1. Place generator on a level surface.
2. See Figure 4-3. Using a Flat Head screw-
driver, turn the lock 1/4 turn clockwise to
open service door (A).
3. Clean area around oil fill.
4. Remove oil fill cap and wipe dipstick clean.
See Figure 4-1.
Figure 4-1. Engine Oil Fill
5. To check oil level, insert dipstick into oil
filler neck without screwing it in. See
ure 4-2.
Figure 4-2. Safe Operating Range
6. Remove dipstick and verify oil level is
within safe operating range.
7. Add recommended engine oil as neces-
sary.
14
SAE 30
WARNING
NOTE: Verify oil level often during filling pro-
cess to ensure overfilling does not occur.
8. Install oil fill cap/dipstick and hand-tighten.
NOTE: Some units have more than one oil fill
location. It is only necessary to use one oil fill
point.

Change Engine Oil

000399
Accidental start-up. Disconnect spark plug wires when
working on unit. Failure to do so could result in death
or serious injury.
When using generator under extreme, dirty,
dusty conditions, or in extremely hot weather,
change oil more frequently.
NOTE: Don't pollute. Conserve resources.
(000139)
Return used oil to collection centers.
Change oil while engine is still warm from run-
ning, as follows:
1. Place generator on a level surface.
2. See
driver, turn the lock 1/4 turn clockwise to
open service door (A).
A
B
Figure 4-3. Access Door and Oil Drain Covers
3. Disconnect the spark plug wire from the
000115
spark plug and place the wire where it
cannot contact spark plug.
4. Clean area around oil fill and oil drain plug.
Fig-
5. See
bolt access cover (B).
6. See
cover on bottom of unit below the oil drain
bolt (C). Use 10mm socket with extension
to remove oil drain bolt to drain oil into a
suitable container.
005484
Figure 4-4. Remove Oil Drain Rubber Cover
WARNING
Figure 4-3. Using a Flat Head screw-
Figure 4-3. Remove rubber oil drain
Figure 4-4. Remove oil drain rubber
Owner's Manual for Portable Generator
(000141)
007847
C
009207