Drain Facility; Flooring; Location Considerations; Alcove Or Closet Installation - Samsung WF431AB Manual Del Usuario

Drain facility

The recommended height of the standpipe is 18 in/46 cm. The drain hose must be routed through the drain
hose clip to the standpipe. The standpipe must be large enough to accept the outside diameter of the drain
hose. The drain hose is attached at the factory.

Flooring

For best performance, you must install your washer on a solidly constructed floor. Wood floors may need to
be reinforced to minimize vibration and/or unbalanced load situations. Carpeting and soft tile surfaces are
contributing factors to vibration which can cause your washer to move slightly during the spin cycle.
Never install your washer on a platform or weakly supported structure.

Location considerations

Do not install your washer in areas where water may freeze, since your washer will always retain some
water in its water valve, pump, and hose areas. Freezing water can damage the belts,the pump, hoses and
other components.

Alcove or closet installation

MINIMUM CLEARANCES FOR CLOSET AND ALCOVE INSTALLATIONS:
Sides – 1 in / 25 mm
Rear – 5.9 in / 150 mm
If the washer and dryer are installed together, the closet front must have at least a 72 in²
(465 cm²) unobstructed air opening. Your washer alone does not require a specific air opening.
A
(2.5 cm)
A. Recessed area
B. Side view - closet or confined area

Undercounter installation(washer only)

WF431ABP-03016A-07_EN_v1.indd Sec2:11 WF431ABP-03016A-07_EN_v1.indd Sec2:11
1 in.
(2.5 cm)
1 in. 27 in. 27 in.
(68.6 cm) (68.6 cm)
40 in.
(101.6 cm)
Top – 17 in / 432 mm
Closet Front – 2 in / 51 mm
B
1 in. 2 in.
(2.5 cm) (5 cm)
1 in. 27 in. 1 in.
(2.5 cm) (68.6 cm) (2.5 cm)
17 in.
(43.2 cm)
31.9 in. 5.9 in.
(81.1 cm) (15 cm)
Installing your washer _11
2012-05-09 2012-05-09 2:17:23 2:17:23