Important Note To Installer; Removing The Shipping Bolts; Selecting A Location - Samsung WF431AB Manual Del Usuario

IMPORTANT NOTE TO INSTALLER

Please read the following instructions carefully before installing the washer.
These instructions should be retained for future reference.
We recommend you hire a professional for installation of this washer.
STEP 1

Removing the Shipping Bolts

Before using your washer, you must remove all shipping bolts
from the back of the unit.
1. Loosen all the bolts with the supplied wrench.
2. Slide the bolt and spacer up and remove the bolt with the
spacer through the hole in the rear wall of your washer.
Repeat for each bolt.
3. Cover the holes with the supplied Bolt Hole Covers (See page 9).
4. Keep the shipping bolts and spacers for future use.
STEP 2

Selecting a Location

Before you install your washer, make sure the location:
•
•
•
•
•
•
•
STEP 3
Installing your Washer
1. If you use a stand pipe, make sure the
connection between the drain hose
and the standpipe is NOT airtight. The
standpipe must be at least 18 in or 46 cm
high.
You must always exercise caution to
avoid collapsing or damaging the drain
hose. For best results, the drain hose
should not be restricted in any way – by
elbows, couplings, or excessive length.
For situations where the drain hose
cannot be conveniently elevated to at
least 18 in or 46 cm, the drain hose must
be supported.
Do not insert the drain hose too far into
the stand pipe: 6 - 8 inches, and no more.
WF431ABP-03016A-07_EN_v1.indd Sec2:13 WF431ABP-03016A-07_EN_v1.indd Sec2:13
Has a hard, level surface
Is away from direct sunlight
Has adequate ventilation
Will not freeze (tempuratures never below 32 °F or 0 °C)
Is away from heat sources such as oil or gas
Has enough room for the power cord.
Doesn't have any carpeting that will obstruct ventilation openings.
Laundry tub
96" Max
18" Min
Installing your washer _13
Stand pipe
Hose
retainer
96" Max
18" Min
Tie strap
2012-05-09 2012-05-09 2:17:23 2:17:23