Blowing Feature - Craftsman 125.12001 Manual Del Operador

Operation (continued)

Blowing Feature

!
WARNING: Always wear safety goggles complying with ANSI Z87.1 (or in
Canada, CSA Z94.3) before using blower.
!
WARNING: Keep bystanders clear from blowing debris.
!
WARNING: Wear a dust mask if blowing creates dust that might be inhaled.
1 2
2
This Wet/Dry Vac has blowing capabilities.
To use the blower feature follow the
instructions listed.
1. Verify that the power cord is
disconnected from the outlet. (Fig.1)
2. Make sure the collection tank is empty
before using as a blower.
3. Remove hose from the vacuum port.
4. Insert the larger end of the hose into the
blowing port on the back side of the
power head. (Fig. 2)
5. Fit the desired attachment to the hose.
6. Ensure the power switch is turned OFF
and plug into the power supply. (Fig. 3)
7. Before turning ON the vac, fi rmly hold
the loose end of the hose. Turn the
motor on by pressing the switch to the
'I' ON position. (Fig. 4)
3
4
10