Installing & Cleaning; Cleaning & Disinfecting The Wet/Dry Vac; Storage - Craftsman 125.12001 Manual Del Operador

Maintenance (continued)
Installing & Cleaning Foam Sleeve Filter
1
Installing Foam Sleeve Filter
1. Verify that the power cord is
disconnected from the outlet. (Fig. 1)
2. Remove power head and place in
upside down position. Follow
instructions to remove cloth fi lter.
3. Carefully slide foam sleeve fi lter
down over the fi lter cage making sure
the whole cage is covered. (Fig. 2 & 3)
4. Place power head on collection tank and
secure latches.
Cleaning & Disinfecting the Wet/Dry Vac
To clean the collection tank:
1. Dump debris out.
2. Wash collection tank thoroughly with
warm water and mild soap.
3. Wipe out with dry cloth.
Before prolonged storage or as needed
(i.e. after waste water pick up) the
collection tank should be disinfected.

Storage

Before storing your vac, the collection tank
should be emptied and cleaned. The cord
should be wrapped around the unit and the
hose should be stored as described in this
manual. Accessories should be kept in the
same area as the vac so they can be
readily available. The vac should be stored
indoors.
2 3 4
Cleaning Foam Sleeve Filter
1. With the removed power head in the
upside down position, carefully
remove foam sleeve fi lter. (Fig. 4)
2. Use a mild soap and water solution to
wash foam sleeve fi lter and rinse with
clean water. (Fig. 5)
3. Allow fi lter to air dry before installing and
using again.
To disinfect the collection tank:
1. Pour 1 gallon of water and 1 teaspoon
chlorine bleach into the collection tank.
2. Let solution stand for 20 minutes,
carefully swishing every few minutes,
making sure to wet all inside surfaces
of the collection tank.
3. Empty collection tank after 20 minutes.
Rinse with water until bleach smell
is gone. Allow collection tank to dry
completely before sealing the motor on
the collection tank.
12
5