Unpacking Your Wet/Dry Vacuum & General Assembly - Craftsman 125.12001 Manual Del Operador

Assembly (continued)
Before beginning assembly of product, make sure all parts are present. Compare
parts with Carton Content List and diagram. If any part is missing or damaged, do
not attempt to assemble the product. Contact customer service for replacement
parts.
Estimated Assembly Time: 15 minutes
Tools Required for Assembly: Drill, Screwdriver
Helpful Tools: Level
1 2
7 8
13
!
WARNING: Do not plug in power
cord to power outlet, make sure
plug is disconnected before
assembling the wet/dry vac.
UNPACKING YOUR WET/DRY
VACUUM & GENERAL ASSEMBLY
1. Verify that the power cord is
disconnected from the outlet. (Fig. 1)
2. Undo the latches. (Fig. 2)
3. Lift the power head off the collection
tank and place on a fl at clean surface.
(Fig. 3)
4. Remove the contents from inside the
collection tank, make sure you have
all contents as listed on page 5.
(Fig. 4)
3
1
2
9 9
6
4
5
10 11
5. Find the handle and insert the ends
into the handle opening on the power
head. Apply pressure to lock the
handle into place. (Fig. 5)
6. For dry vacuum cleaning, install the
supplied reusable cloth fi lter. (Fig. 6)
See page 11 for fi lter installation.
7. For wet vacuum cleaning, install the
supplied foam fi lter. (Fig. 7) See page
12 for fi lter installation.
8. Place the power head back on the
collection tank, aligning the top
section with the latches, and snap into
place. (Fig. 8 & 9)
9. Insert the larger end of the hose into
the desired port. (Fig. 10)
10. Choose the desired accessories and
insert onto the end of the hose. (Fig. 11)
6
12