Initial Use - Beurer babycare BY 33 Instrucciones Para El Uso

6. Initial use

Baby unit
Operation with mains part
Position the baby unit so that it is in an elevated position and is not in proxi-
mity to any other devices that may cause interference.
Using the mains part plug, connect the baby unit to a socket.
The device automatically switches on.
The power LED will light up green.
To switch the device off press the ON/OFF button for at least 2 seconds or
unplug the mains part. The power LED will go out.
To switch the device on again press the ON/OFF button for approx. 2 seconds.
Parent unit
Set up the parent unit in the room where you are going to be.
Battery operation – charging
To ensure optimal safety, the parent unit is designed so that it can
only be operated with batteries inserted.
The battery must be charged for at least 16 hours before the device can be
first used independently of the mains; you may use the device during this
period.
Switch the parent unit on by pressing the
LED of the parent unit will light up green. The device is active.
If the parent unit battery is low the unit will beep twice. If the device is not
connected to a socket, it will switch off automatically after a short period. The
power LED will go out.
button for 2 seconds. The power
21