Quick PAJ 1T MSC Manual De Instalacion Y Uso página 12

CHARACTERISTICS AND INSTALLATION
EN
PAJ 1T MSC REMOTE COMMAND
1-lever MSC drive remote command for thruster
The PAJ 1T MSC is designed to proportionally control the MSC series drives (MSC400 and MSC800) via analog port for
thrusters produced by Quick
The PAJ 1T MSC command offers the following advantages:
• Simple and intuitive user interface.
• Can work in a wide range of ambient temperatures.
• Possibility to connect up to 2 commands at the same time.
• Easy connection via Ethernet patch cable.
• Automatic priority system.
• Automatic deactivation.
• Acoustic and light signals.
INSTALLATION
The installation of the remote command must be carried out by qualified personnel.
BEFORE USING THE COMMAND CAREFULLY READ THIS USER'S MANUAL. IF IN DOUBT, CONTACT YOUR
NEAREST DEALER OR "QUICK
F
In case of discordance or errors in translation between the translated version and the original text in the Italian
language, reference will be made to the Italian or English text.
F
This device was designed and constructed for use on recreational crafts.
Other forms of use are not permitted without written authorization from the company Quick
The PAJ 1T MSC has been designed and constructed solely for the tasks and purposes given in this User's manual. Quick
company shall not be held responsible for any direct or indirect property damage caused by inappropriate use of the con-
trol, incorrect installation or possible errors present in this manual.
THE OPENING OF THE COMMAND BY UNAUTHORIZED PERSONNEL MAKES THE WARRANTY VOID.
THE PACKAGE CONTAINS: PAJ 1T MSC command - cover - gasket - screws for fixing - drilling template - conditions of
warranty - manual of installation and use.
INSTALLING THE COMMAND
The typical installation procedure is described herein.
Needless to say, it is not possible to describe a procedure applicable for all situations that may be encountered.
Adapt this procedure to satisfy your own personal requirements.
Locate the most suitable position to house the control following the recommendations given below:
• The control should be installed in a place where it can be easily read by the operator.
• Select a clean, smooth and flat area.
• The 4 screws should be fastened onto a level surface. The base of the command may be damaged mechanically if
the screws are tightened onto a curved surface.
• Access from the rear must be available for installation and maintenance purposes.
• Enough space should be present behind the spot selected where the back of the command and connectors are to be placed.
• The back of the command should be protected against humidity or water contact.
• Pay attention when drilling the panel or parts of the boat. This hole should not weaken or break/crack the boat's
structure.
12
.
®
" CUSTOMER SERVICE.
®
.
®
®
PAJ 1T MSC REV001A