Monster Power PRO 3500 Manual Del Propietário página 13

MONSTER PRO 3500 POWERCENTER FEATURES
1. Breaker Open: When this LED is on, the thermal circuit breaker has tripped, due to overload, to protect your
equipment. Find the reason for overload, correct it, and press the breaker in to reset.
2. Front Dimmer: This knob controls the front panel flexible MonsterLight (Push On/Push Off, clockwise brighter,
counter-clockwise dimmer). The lamp can be turned on even when the unit is switched off. due to improper
grounding of your home's outlets.
3. Numerical Display: Seven-character 1-line LED numeric display indicates both the AC voltage the unit is receiving
from the wall, and the amount of current being drawn by your equipment.
4. Thermal Circuit Breaker: Protects the PowerCenter from power overload.
5. ON/OFF Switch: Once the PowerCenter is plugged into a properly grounded 120V outlet, operating the switch
will provide AC power to the components plugged into the PowerCenter's Switched and Switched (Timed) outlets.
Release this button to shut down components.
6. Front 12V XLR Lamp: Provides 12 volts (pin 2) to the flexible MonsterLight.
7. Ground OK: When this LED is On, the PowerCenter is plugged into a properly grounded 120V AC power outlet.
If the LED is Off, unplug the PowerCenter immediately. Monster Cable
due to improper grounding of your home's outlets.
8. Wiring Fault: This LED indicates if the Line and Neutral wires from the wall outlet to the PowerSource are reversed.
Unplug the unit immediately and consult your electrician.
9. Clean Power On: This LED indicates that the PowerCenter is providing filtered AC power to all
connected components.
10. Abnormal Voltage: When this LED is On, the PowerCenter warns of unstable power conditions (over 130 VAC
or under 90 VAC). Outside of these limits, the PowerCenter's T2 circuitry will disconnect all components from power,
until the voltage returns to normal levels.
All manuals and user guides at all-guides.com
is not responsible for equipment damage
®
7