Maintenance; Setting Blade Inclination To 90 - Sima POLYPANEL 125 Manual De Instrucciones

10. MAINTENANCE

The table saws require a simple maintenance as per the following operations:
 Remove all possible residuals of cut materials that can cling into the rolling tracks of the cutting bridge.
 Replace as soon as possible electrical cables that cause power cuts, breaking or any other disrepair.
 If the machine is not covered, wrap it with an impermeable cloth.
 At the end of each day, unplug the machine.
 Maintenance operations should be performed by people who the machine and its functioning.
Before performing any maintenance or cleaning operations, the electricity cable should be unplugged.
In case you observe any anomalies or mal functioning, let a technician check the machine.
Take into account the safety recommendations mentioned in this manual.
It is prohibited to independently make any change in some parts, components or characteristics
of the machine. The manufacturer shall in no case be responsible for the consequences that may
derive from a breach of these recommendations.
10.1 SETTING BLADE INCLINATION TO 90 °.
The cutter table saw are shipped well regulated so that when mounting the blade cut at an angle of either 90 ° or 45º.
If for some unforeseen blow or any other cause to be off, go to the nearest service center for repair.
1. Disconnect the machine from the network and remove the blade safeguard.
2. Remove the blade safeguard. Using a square located on the main and
reference in the face of the blade will observe the parallelism of the two.
3. Adjust it with the screws at each end by loosening its screws to get the blade
face is coincident with the vertical face of the square.
4. Having gained the position, re-tighten the nuts on the throttles and ride the
backup disk.
12
ENGLISH