Publicidad
CARACTERÍSTICAS Y COMPONENTES:
Unidad de
La Bomba
Cuenca Ducha
Extensible
CONFIGURACIÓN DEL CUENCO DEL DEPÓSITO:
Paso 1:
Retire la tapa del cuenco del depósito
del cuenco del depósito.
Paso 2:
Agarre el borde del cuenco del depósito y coloque
los pulgares hacia adentro. Presione suavemente
para abrir el cuenco del depósito.
(Imagen A)
NOTA:
NO lo contraiga luego de la primera expansión.
CONFIGURACIÓN DE LA BOMBA:
Paso 1:
Gire la tapa de la unidad de la bomba
de izquierda a derecha.
(Imagen A)
Paso 2:
Desajuste el tornillo de la bomba que sujeta
la tapa del compartimento de pilas en su lugar
y levántela para abrir.
(Imagen B)
Paso 3:
Inserte las 6 pilas "AA" nuevas en el compartimento
para pilas. Asegúrese de colocar las pilas
adecuadamente y en la dirección correcta.
(Imagen C)
Paso 4:
Cierre la tapa del compartimento de pilas y ajuste
el tornillo. NO AJUSTE DEMASIADO EL TORNILLO.
Reemplace la tapa de la unidad de la bomba y gire
la tapa de izquierda a derecha.
NO AJUSTE DEMASIADO LA TAPA.
(Imagen D)
Adaptador de tela
Bañera Para
Niño Pequeño
Mango Rociador
A
A
B
C
D
PUMP INSTALLATION:
Step 1:
Place top of Pump Unit into the pump opening
on the underside of the Reservoir Basin Cover.
Match the tabs on Pump Unit to the Reservoir
Basin Cover.
(Figure A)
Step 2:
Twist Pump Unit counter clockwise. Turn until
the pump is locked into place. The hose will now
be on the right side of the Pump Unit and notch.
(Figure B)
Step 3:
Place hose in notch and place Reservoir
Basin Cover onto Reservoir Basin.
(Figure C)
SHOWER SET UP:
Step 1:
Fill the Reservoir Basin with water through the opening on top.
(Figure L)
Looking down into the opening, fill only to the divider inside the reservoir
(about 2 inches below bottom edge of opening). The Reservoir Basin
contains enough water for a complete bath. If necessary, refill the reservoir.
Always test water temp before and after filling.
Step 2:
Never use shower in a tub or sink
with more than 1 in (2.5 cm) of water.
Point the Sprayer Handle and press the button on the top of Pump Unit
to turn the sprayer on. Test water temp before pointing at baby.
Press button again on the Pump Unit to turn the sprayer off.
NEWBORN BATH SLING IN INFANT TUB:
NOTE: Never place more than 1 inch of water in tub.
Always keep the drain open in the adult bath tub and
infant tub. Remove sling from plastic bag. Securely clip
the 4 clips onto the baby bath (Figure A and B). There
are special slots for the 4 clips marked on the bath
tub. Place the baby bath into a full sized adult bath tub
or on a flat surface. Always check water temperature
prior to bathing child. Bath water temperature should
never exceed 100ºF (37.8ºC). Place newborn carefully
onto bath sling to bathe.
NEVER leave child unattended while in bath.
A
B
C
L
B
A
Publicidad
