Shutting Down; Troubleshooting - ARIETE CAFE MATISSE 1363 Instrucciones De Utilización Y De Seguridad

Cleaning the cup grill
container :
8
Note: Empty the water collection container
odically
Remove the cup grill
running water
Remove the water collection container
it and rinse it out under running water
Cleaning the surface of the machine
CAUTION!
Only clean the permanent components of the machine
with a damp cloth to avoid damage to the casing
Descaling
Good maintenance and regular cleaning protect the
device, ensure a longer lifespan and limit the uild up
of limescale If the device still does not function

Troubleshooting

Problem
Not releasing steam
Water ows out of
the side of the lter
holder
10
20
1363_Espressomaschine_Content_IT_GB_FR_DE_ES_PT_NL_GR_RU_AE.indd 20
and the water collection
7
peri-
8
and rinse it out under
7
, empty
8
Cause
Too little water in the water tan
the pump has no suction
The opening of the steam pipe
loc ed
The lter is pro a ly too full, mean-
13
ing the lter cannot e properly
13
screwed into the frame
There are its of ground coffee on the
seal of the coffee lter frame
The hole in the silicone perforated
dis is loc ed
12
properly after some time ecause hard water and very
calcareous water have primarily een used, the lime-
scale must e removed to solve the pro lem For this
purpose you should only use the Ariete descaling agent
NO AL with a citric acid ase
This product can e purchased easily at an Ariete cus-
tomer service centre Ariete accepts no lia ility for dam-
age to components of the Espresso machine from the
use of non-compliant products with chemical additives
Follow the instructions on the instruction decalcifying
agent lea et

Shutting down

In case of shut down, you must detach the machine
from the power supply, empty the water tan and the
collection container and clean the device (see the
chapter leaning the device In case of scrapping,
you must ta e care to dispose of the different individual
parts according to the applica le laws of the country
in which the device is eing used
Solution
hec whether the water tan
18
inserted correctly and that there is enough
water in the water tan
tan with fresh, still water up to the
18
A mar
is Remove any lm which has uilt up at the
17
opening of the steam pipe
Remove the lter holder
cause this may lead to residual pressure and
a spraying of water lean the frame with a
small sponge Try it again with the correct
amount of coffee
Try it again with the correct amount of coffee
Rinse out the silicone perforated dis
der running water Turn it so that the middle
opening can e un loc ed y removing the
coffee powder that it stuc in it
has een
18
Fill the water
18
with a pin
17
very slowly, e-
10
un-
12
07.08.15 09:12