Functional Description - Milwaukee M18 2890-20 Manual Del Operador

FUNCTIONAL DESCRIPTION

1
3
4
7
11
MODE
12
13
CLOCK
1. Antenna
2. Auxiliary compartment
3. Cord wrap
4. Cord
5. Backup-battery com-
partment
6. Battery bay
7. AUX storage
8. Stereo AUX jack
9. USB power outlet
2
3
5
6
8 9
PRESET
EQ
14
10. Display
11. Mode button
12. Seek/adjust
down
13. Clock button
14. On/off / Volume
knob
15. EQ button
16. Seek/adjust up
17. Preset button
WARNING
cific charging instructions, read the operator's
manual supplied with your charger and battery.
Inserting/Removing Battery Pack
Insert the battery pack by sliding it into the battery
bay.
To remove the battery pack, pull the battery pack
off of the bay.
Low Battery Indicator
When the radio is powered by a battery pack, a low
battery indicator will be displayed when the battery
pack needs to be charged.
Battery Pack Protection
To protect the life of the battery pack, the radio will
shut off when the battery's charge becomes too low.
If this happens, remove the battery pack and charge
it according to the charger's instructions.
Installing an Auxiliary Device
Open the Auxiliary Compartment to connect an MP3
player, CD player, or other audio device using the
stereo auxiliary jack. Small devices (less than 3-1/4"
wide, 7-1/4" high, and 1-1/8" thick) can be stored in
the compartment during use.
This jack can be used to charge a cell phone, power
a CD player or any other device that uses less than
2.1 A of DC electrical current. Function will only occur
when the radio is plugged into an outlet, or the radio
is on and an M18™ battery pack is inserted. The
USB Power Outlet will not function off of a battery
pack with the radio off.
NOTE: Any device that uses more than 2.1 A of DC
electrical current will trip a self-resetting function and
disable the output.
WARNING
The following care should be taken to prevent
such an incident:
• Make sure the positive (+) and negative (-) bat-
tery terminals are positioned correctly.
10
• Do not mix new and old batteries together, or
mix different types of batteries.
• Do not try to recharge non-rechargeable batter-
ies.
17
If chemicals from the batteries come in contact
with your skin, wash them off immediately with
water. If chemicals leak onto the radio, clean the
16
radio completely.
Changing Back-up Batteries
15
To hold station presets and clock time when the bat-
tery pack is removed and the
radio is unplugged, 2 AAA
batteries are required.
1. Remove battery pack
and unplug radio.
2. Remove the screw and
battery cover.
3. Insert two (2) AAA
batteries according to
matching positive (+)
and negative (-) marks.
4. Replace the battery
cover and screw.
4
ASSEMBLY
Recharge only with the charger
specified for the battery. For spe-
USB Power Outlet
Batteries may leak chemicals or
may explode if used incorrectly.