KENMORE ELITE 795.5185 Manual De Uso página 33

8. FLUSH OUT THE TUBING
Turn the main water supply on and
p ush out the tubing until the water
is clear.
Shut the water oç at the water
valve after about one quart of
water has been p ushed through the
tubing.
9. CONNECT THE TUBING TO THE
REFRIGERATOR
NOTE: Before making the connection to the
refrigerator, be sure that the refrigerator power cord is
not plugged into the wall outlet.
1. Remove the plastic p exible cap from the water valve.
2. Place the compression nut and ferrule (sleeve) onto the
end of the tubing as shown.
3. Insert the end of the copper tubing into the connection
as far as possible. While holding the tubing, tighten the
o tting.
Back of refrigerator
Tubing Clamp
¼" (6.35 mm)
Compression
Nut
Ferrule
(Sleeve)
10. TURN THE WATER ON AT THE SHUTOFF VALVE
11. PLUG IN THE REFRIGERATOR
¼" (6.35 mm) Tubing
12. START THE ICEMAKER
Refrigerator
Connection
33
CONNECTING THE WATER LINE
Tighten any connections that leak.
CAUTION: Check to see if leaks occur at the water line
connections.
Arrange the coil of tubing so that it does not vibrate
against the back of the refrigerator or against the wall.
Push the refrigerator back to the wall.
Set the Ice Maker button to ON.
The icemaker will not begin to operate until it reaches
its operating temperature of 15°F (–9°C) or below. It
will then begin operation automatically if the Ice Maker
button is set to ON.