Access to the Messages of the telecom network answering machine
1. When the network answering machine is Info, the telecom network can receive
and keep voice message for the phone, while it sends a message waiting signal to
this telephone to power on the Mens LED, then the LED is blinking to indicate.
2. Press Cont key, the number "069" is dialled out to telecom network for getting
back the voice message.
3. Hang up the handset or press
Deactivate of the telecom network answering machine
1. At on-hook or off -hook state, press Mem and Cont keys.
2. The number "#10#" is dialled out and displayed on LCD.
3. Hang up the handset or press
machine is deactive.
CALLER ID
When the telephone is receiving an incoming call, the incoming call number
is displayed on LCD. If it isn't answered, the number will remain on LCD until the
telephone goes to off -hook and then returns back to on-hook again.
LCD DISPLAY
Numeric display with one line of 16 big seven-segment digits. In on-hook state, the
LCD displays nothing. When the user picks up the handset or press
is detected as active, then LCD will display the symbol "_". Upon activation of any
the mentioned functions above, LCD will present the messages corresponding to
each case.
VOLUME CONTROL
Ringing volume control
Slide the three-position switch Ring (HI/LO/OFF) to select the ringing volume for
incoming calls. Please note if OFF position is selected, the telephone doesn't ring
for any incoming call. If you don't want to be disturbed by ringing tone some time,
you can slide the switch to OFF position, but don't forget to return it to HI or LO
position after that.
Handset volume control
Slide the two-position switch Auric(HI/LO) to select the comfortable handset
conversation volume.
Hands-free volume control
Slide the two-position switch Speaker(HI/LO) to select the comfortable hands-free
conversation volume.
ENG
key to hang up, the Mens LED stops blinking.
key to hang up, now the network answering
15
key, the line