Usr5432 Installation Guide; Prepare For Installation - U.S.Robotics MAXg Bridge Guía De Instalación Rápida

U.S. Robotics Wireless

USR5432 Installation Guide

Installation
Package Contents:
USR5432 Wireless MAXg Bridge
Quick Installation Guide
One (1) Ethernet cable

Prepare for installation

For Bridge mode, you must be using a wireless router or access point that supports WDS
(Wireless Distribution System). If you select Bridge mode, you will be able to select either WPA
PSK (AES), WPA PSK (TKIP), WEP Open, or WEP Shared for the encryption method. If you select
Infrastructure mode, you will be able to select either WPA2 PSK (AES), WPA2 PSK (TKIP), WPA PSK
(AES), WPA PSK (TKIP), WEP Open, or WEP Shared for the encryption method. If you select Ad
hoc, you will only be able to select either WEP Open or WEP Shared for the encryption method.
You must have administrator rights on your computer in order to install this product.
Be sure to find out what letter your CD-ROM drive uses before you begin installing your new prod-
uct. You will need to know this to install your software.
Connecting the Wireless MAXg Bridge
Note: For the most updated information, visit: http://www.usr.com/support/.
You can also refer to the User Guide on the U.S. Robotics Installation CD-ROM for more
detailed information.
Step One: Connect the Wireless MAXg Bridge
Note: Look at the label on the bottom of the Wireless MAXg Bridge and write down the
LAN MAC address listed before you physically place the Wireless MAXg Bridge. You will
need this for future reference.
A. Connect the antenna to the Wireless MAXg Bridge.
MAX
5VDC power supply
Installation CD-ROM which includes User Guide
Detachable antenna
A
Wireless MAXg Bridge
g Bridge
1