Maintenance; Battery Pack; Charger Maintenance - GreenWorks Commercial GB 500 Manual Del Propietário

MAINTENANCE

WARNING
In order to avoid personal injury and the risk of fire and electric shock, remove the battery pack
before adjusting, inspecting, or cleaning the blower.
Cleaning
Remove the battery pack.
1. Brush or blow dust and debris out of the air vents using compressed air or a vacuum. Keep
the air vents free of obstructions, sawdust, and wood chips. Do not spray, wash, or immerse the
air vents in water.
2. Wipe off the housing and the plastic components using a moist, soft cloth. Do not use strong
solvents or detergents on the plastic housing or plastic components. Certain household cleaners
may cause damage, and may cause a shock hazard.

Battery Pack

• Store the battery pack fully charged.
• Once the light on the charger turns solid green, remove the battery from the charger and
disconnect the charger from the outlet.
• Do not store the battery pack on the tool.
• After charging, the battery pack may be stored in the charger, as long as the charger is not
plugged in.

Charger Maintenance

• Keep the charger clean and clear of debris. Do not allow foreign material to get into the
recessed cavity or onto the contacts. Wipe the charger clean with a dry cloth. Do not use
solvents or water, and do not place the charger in wet conditions.
• Unplug the charger when there is no battery pack in it.
• Fully charge the batteries before placing them in storage.
• Store the charger at normal room temperature. Do not store it in excessive heat. Do not use
the charger in direct sunlight. Recharge at room temperature between 45˚F and 104˚F (7˚C and
40˚C). If the battery pack is hot, allow it to cool down inside of the charger. The battery will begin
charging once it has returned to room temperature.
16