Snapper SXDCS82 Manual Del Propietário página 23

OPERATION
BUCKinG LOGS UnDER STRESS
When the log is supported on one end, cut 1/3 the diameter from the underside. Then make
the finished cut by overbucking to meet the first cut. When the log is supported on both ends,
cut 1/3 of the diameter from the top overback. Then make the finished cut by under bucking
the lower 2/3 to meet the first cut.
Log Supported At One End
Finishing Cut
OVERBUCKinG
Begin on the top side of the log with the bottom of the saw against the log; exert light pressure
downward. Note that the saw will tend to pull away from you.
UnDERBUCKinG
Begin on the under side of the log with the top of the saw against the log; exert light pressure
upward. During under bucking, the saw will tend to push back at you. Be prepared for this
reaction and hold the saw firmly to maintain control.
Load
1St Cut 1/3 Dia
Log Supported At Both Ends
Load
23
1St Cut 1/3 Dia
Finishing Cut