Driveline Installation; Hydraulic System Installation (Optional) - Cosmo PDC 400 Manual De Uso

4.3.

DRIVELINE INSTALLATION

Before using the pto shaft, please consult the use and maintenance manual attached to the pto
shaft.
In case that the pto shaft, supplied with the machine, is not used, please check that the cowlings of
the machines and of tractors are overlapped to the pto shaft's shield of 5 cm., at least.
For a correct and safe operation of the machine, please use exclusively pto shafts with CE mark.
Please use pto shafts with integral shields.
• Grease periodically, the pto shaft following the instruction supplied by the pto shaft manufacturer
(see the use and maintenance manual of the pto shaft).
• Observe the sense of assembly of the pto shaft, as indicated by the manufacturer and shown on
the outer cover of the shield (tractor drawing on the external tube of the pto shaft towards the power
take-off of the same tractor).
• Fasten the safety ant-rotation chains after making sure that the connection between the pto shaft
and the gear box is well locked. Use for this connection an hexagonal head screw 8.8 10x70
UNI 5737 with the relative nut.
The length of the pto shaft must be adapted to the type of used tractor.
When the pto shaft is released from the power take-off of the tractor must ALWAYS be laid on the
appropriate support.
COSMO Company is not responsible for the damages caused by an incorrect assembly and use of the
pto shaft.
4.4.

HYDRAULIC SYSTEM INSTALLATION (OPTIONAL)

In order to recognize the element used, please refer to the tables 08 and 09 of the chapter 8 (Parts
breakdown).
1. Assemble the connection plate for hydraulic opening system (ref. 8) on the gear box by using the
screw and the nut (C) already on the gear box.
2. Fixing the hydraulic cylinder (ref. 1) to the connection plate (ref. 8) by using the screw (ref. 4)
hexagonal head 8x30 (mod. PDV500/600) or hexagonal head 8x25 (mod. PDV800/1000/1250),
the self-locking nut M8 ( ref. 6), the two washers 8x17 (ref. 7) and the bushing 13x8x7 (ref. 9).
3. The hydraulic cylinder stem must be connected to the lever plate in the hole B. Insert the screw
hexagonal head 12x60 (ref. 3) in the hole B, screw up the nut M12 (ref. 10) insert the screw in one
of the two cylinder holes and fix it by the self-locking nut M12 (ref. 5).
Pendular Spreader PDV - PDHV models
ATTENTION!
Check the rotation sense and the speed regulation of the power take-off of the
tractor to be at 540 rpm, as the machine is projected for this kind of speed.
17