General Maintenance - Cosmo PDC 400 Manual De Uso

6. GENERAL MAINTENANCE

The ordinary maintenance criteria we suggest, are based on the company experience and on the advices
and suggestions from our customers.
Such criteria are not exhaustive can be further integrated also with the collaboration of the customers that
we thanks in advance.
A good ordinary maintenance keeps the operating costs of the machine low and provide an integral
exploitation of its potentialities.
In damage case, the operator must stop the machine immediately, assess the entity of the problem and
proceed with eventual actions on the machine.
If pressure water or compressed air is used for the cleaning of the machine, it is necessary to protect
oneself with proper glasses or protection masks and to remove eventual persons or animals near the
machine. Do not use inflammable fluids.
Every 8 hours of effective job, control the tightness of all nuts and bolts.
In case of anomalous vibrations, verify the corrected tightness of all the nuts and bolts and the lubrication
of the gear box.
The excessive vibration of the machine, besides the specific annoyance, is dangerous and damaging for
the entire structure subjecting the mechanical parts to more and more stress cycles compared to the
advice pictures.
As regards particular actions that the user does not know or regarding broken parts replacing which are
not shown in this manual, it is necessary to consult specialised personnel, making use of the Assistance
service by the manufacturer or its distributors.
Pendular Spreader PDV - PDHV models
ATTENTION!
Whichever work of maintenance, regulation and cleaning must be carried out with
the machine on the ground (in stable conditions), engine turned off, handbrake
set, key of ignition off and removed from the ignition board.
ATTENTION!
For the maintenance operations, always use the fit Individual Protection Devices
(accident-prevention footwear and gloves) and to prepare all the accident-
prevention steps for the type of operation in course.
25