Apt Ip Silver - Encoder / Decoder Quick Start Notice; Before You Start; Configuring Your Nextgen Product - Worldcast Systems APT IP Silver Guía Rápida

English version
APT IP Silver – Encoder / Decoder
Quick start notice

1. Before you start

Make sure the box you received contains:
 1 external power supply
 1 box including: Documentation and software CD, Quick Start Guide.
!
This unit does not deal with network related security issues. It is up to the user to set it in a secured
environment such as a private network, VPN, behind a firewall...WorldCast Systems cannot be held
responsible for the consequences of a security breach on the operating network.

2. Configuring your NextGen product

1. Configure each unit separately as all units are shipped from APT with the same default IP address.
If two units are deployed on the same IP address, this will cause an IP addressing conflict.

Once you've followed the entire procedure for the first unit, you will need to start over for the second
one.
2. Ensure that you have both units configured properly (that you wish to make the connection with)
and connected to a switch and the PC first before deploying on live networks.
3. Connect your Silver unit to your switch/router/network via the LAN port (ETH0) on the back of the
unit with an Ethernet cable (see connection diagram on the last page of this quick start guide).
Note: all Codecs are set up with the same default address – make sure that you have changed
these, in order to avoid an address conflict.
4. Open a web browser and type the following IP address: 192.168.100.110. This may be changed if
required using the System/Network page of the web interface. Ensure that your PC's IP address is
set for the same network (192.168.100.xxx / 255.255.255.0)
5. The Default login is: User:
4
Admin Password: admin.
Figure 0-1: Shows the status page after you have logged in successfully