CLEARANCES AND DIMENSIONS
• Dimensions that are shown in Figure 1 (for
24") must be used. Given dimensions provide
minimum clearance. Locate electrical outlet in the
shaded area in the upper left-hand corner of the
cutout. See Figure 4.
• Contact surface must be solid and level. Pay
special attention to the floor on which the Drawer
Microwave will sit. The floor of the opening
should be constructed of plywood strong enough
to support the weight of the oven (about 100
pounds).
• Check location where the Drawer Microwave will
be installed for proper electrical supply.
• Your oven can be built into a cabinet or wall by
itself or under a gas, under an electric wall oven,
or under selected cook top models. See use and
care manual for list of models.
• Be sure that the clearance of the floor between
the wall oven and the drawer microwave is a
minimum of 2-inches.
• The microwave interior will easily accommodate
a 9" x 13" oblong dish or a bag of microwave
popcorn.
• The oven can also be mounted flush. Please see
instructions for flush mounting included with the
Flush Mount Deflector vent.
24" DRAWER MICROWAVE MEASUREMENTS
Figures 1 and 2 contain many drawer microwave
measurements for reference when planning the
drawer location.
This drawer microwave can be installed below any
electric or gas wall oven or under selected cook top
models. See use and care manual for list of models.
Can also be installed using an electrical outlet in
an adjacent cabinet within the areas where the
provided electrical cord can reach. Power cord
access hole in cabinet should be a minimum of 1
1/2" diameter hole and deburred of all sharp edges.
Always allow sufficient power cord
IMPORTANT
length to the electrical outlet to
prevent tension.
Always check electrical codes for requirements.
Installation Instructions
3
24" DRAWER MICROWAVE MEASUREMENTS
(Continues)
Suggested electrical
outlet location*
4"
22
/
"
1
8
opening
Allow
/
"
7
8
overlap
23
/
"
1
2
min
depth
36"
countertop
height
24"
cabinet min.
4
/
"
11
16
1
/
3
15
/
"
15
16
(6")
5"
14
to bottom
Allow
/
"
of Anti-Tip
3
16
overlap
14
/
"
13
16
opening
Allow
/
"
7
8
overlap
Allow
/
"
7
16
overlap
18
/
" to top
1
2
Figure 1
21
/
"
5
"
8
4
4"
15"
auto drawer
opening
1
/
"
1
4
door thickness
23
/
"
7
8
Figure 2
Anti-Tip
Block
3
/
"
1
2
/
"
13
16
Block
Floor must
support
100 lbs.
14
/
"
19
32
21
/
"
7
8