Technical Specifications; Benutzerhandbuch - AIRGOO vidaXL FD 186 Instrucciones De Uso Y Seguridad

The motor runs, but it
makes irregular noises
or a knocking noise.
Not enough pressure
when painting or
spraying.
Poor spray pattern.
Motor runs properly,
but no air pressure or
lack of air delivery.
6 Follow all safety precautions whenever diagnosing or
servicing the compressor. Disconnect power supply before
service.
5.2 Model BD air bursh
• Empty the fluid cup and clean it with water or solvent using
a brush.
• Refill the cup with water or solvent, then block the needle
cover with your finger and spray. The air flows will be
pushed back into the nozzle and remove leftover paint from
the air brush.

6 Technical specifications

Type
Power
Speed
DE

Benutzerhandbuch

1 Symbolerklärung
Siehe Bild 1
1. Lesen Sie das Handbuch vor Gebrauch sorgfältig durch.
2. Tragen Sie einen Gehörschutz.
3. Entsorgen Sie Elektrogeräte nicht zusammen mit Ihrem
Haushaltsabfall!
Gemäß der europäischen Richtlinie 2012/19/EU hinsichtlich
elektrischer und elektronischer Geräte und deren Umsetzung in
nationales Recht müssen veraltete elektrische Geräte über eine
umweltgerechte Recyclinganlage gesammelt und entsorgt
werden.
60 | 140285
Bearing is loose or damaged.
Screws in the connection rod are
loose.
Loose air connection(s).
Air hose is damaged.
Screws on cylinder cover are loose.
Loose air connections(s).
The paint is too thick.
The Airbrush nozzle is plugged or dirty.
Valve plate is loose or out of place.
Retainer ring is damaged after
excessive use at high pressure.
Single Cylinder Piston
Compressor with Air Tank
1/6 HP
1450/1700 rmp
Have a qualified service technician replace the bearing.
Tighten the screws, or replace them if necessary.
Check all air connections, and tighten them if necessary.
Replace air hose.
Tighten screws.
Check all air connections, and tighten them if necessary.
Add paint thinner and mix thoroughly.
Clean or change the nozzle.
Open the front cover and make sure the valve plate is in the
proper position. Tighten the screws if necessary.
Have a qualified service technician replace the retainer ring.
Air flow
Auto-stop at 4 Bar (57PSI), and auto re-start from 3
Bar(43PSI)
Working pressure
Air tank
Weight
Dimension
Suitable for airbrush with nozzle size of 0.2mm~1.0mm.
Rated voltage
Rated power
RPM
Safety class
Model Bd air bursh
Nozzle diameter 0.3mm
2 Teileliste
2.1 Airbrush-kompressorsatz
Siehe Bild 2
1 Netzschalter
3 Kabel
5 Hinterbau
7 Stationärer Motor
9 Drehmotor
11 O-Ring
20~23L/min
0~4 bar
3.0L
5.2KG
310X150X310mm
220V-240V~, 50Hz
150 W
1450/min
I
Fluid cup capacity 22cc
2 Hintere abdeckung
4 Kondensator
6 Schraube x4
8 Lager x2
10 Frontkörper
12 Ventilplatte