Fulgor Milano CREATIVE CPH 401 ID X Manual Del Usaurio página 24

Display of errors and
error handling
The over voltage error is indicated by
showing "U" on the rear left display and
"4" on rear right display. For TC-Errors
GB
the display rear left shows "E" and rear
right shows "R" and the according Error
number will be shown with either "0" or the
required number on the front left and "0"
or the required number on the front right
Error code
Er20
Er31
Er47
C
C/-
E/7
E/8
E/9
description
Knob error
Flash error
Wrong configuration data
LIN-communication error
between display unit and
induction
The cooking zone can be
configured if a static "C" is
shown.
The cooking zone will be
configured if a blinking "C"
is shown. After a successful
configuration the relevant
display shows "-".
When the "-" is not
displayed please check the
possible causes of the E/5.
Non assignable faillure.
Fan faillure.
Defect T sensor on
inductor.
display. If one of the rear or front displays
is not available the missing symbol will be
shown alternating with the original on the
remaining display. If a error is only related
to one cooking zone the error message will
be shown on the according display. In this
case the according display also shows the
error number alternating with the error letter.
Possible causes
Knob permanent use of
knob (> 30 s)
µC- defect
Induction needs to be
configured with the
correct configuration
No or interrupted
LINcommunication
It's not an error, the
user is in the serivice
menu.
The user is in the
service menue, it's not
an error.
2. over voltage.
Fan or control electronic
is defect.
Sensor signal out of
valid range; sensor or
electronic is defect.
24
Error recovery
Release the knob
Change display unit
execute new
configuration using the
service menu
Check connecting cable
between display unit and
induction
A suitably pan must be
placed on the relevant
cooking zone.
Wait for the sysmbol "-"
or abort the configuratuib
activities by pressing the
selectkey and the "C"
does not blink anymore.
Exchange the module.
Exchange modul or User
Interface.
Exchange the modul.
Exchange the modul.