Klarstein 10029702 Manual Del Usaurio página 21

installing the Heat Discharge Pipe
1. Rotate joint A and joint B clockwise into the
two ends of heat discharge pipe.
2. Insert joint A of heat discharge pipe (the
side with „TOP" is upwards) into the groove
until you hear a sound.
3. Aim the locating pole of joint B of heat
discharge pipe at the opening of joint C;
rotate it slightly to make joint B and joint C
connect tightly.
4. in order to improove cooling efficiency, the
heat discharge pipe should be as short as
possible and flat withoutcurve to ensure
smooth heat discharge.
5. Correct installation is as shown in figure.
When installing it on a wall, height of hall
should be about 40 cm - 130 cm from floor.
6. If the pipe is bent too much, it would easily
cause malfunctions.
21