Changing The Temperature Scale; Replacing The Battery - Braun ThermoScan IRT 3020 CO Manual De Instrucciones

Ocultar thumbs Ver también para ThermoScan IRT 3020 CO:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Temperature taken is
not within typical
human temperature
range (93.2 –108 °F or
34 – 42.2 °C).
If error persists,
If error still persists,
Do you have any further
questions?

Changing the temperature scale

Your Braun ThermoScan is shipped with the
Fahrenheit (°F) temperature scale activated. If you
wish to switch to Celsius (°C), proceed as follows:
Make sure the thermometer is turned off.
Press and hold down the «start» button. After
about 8 seconds the display will show this
sequence: «°F» / «°C» /...
Release the «start» button when «°C» is shown.
There will be a short beep to confirm the new
setting, then the thermometer is turned off
automatically.

Replacing the battery

6
HI = too high
LO = too low
System error
Battery is
low, but
thermometer
will still
operate
correctly.
Battery is too
low to take
correct tem-
perature
measurement.
The thermometer is supplied
with one 1.5 V type AAA (LR3).
For best performance, we
recommend Duracell
batteries. Insert new battery
when the battery symbol
appears on the display.
Open the battery compartment.
Remove the battery and replace
with new battery, making
sure the poles are in the right
direction. Slide battery door
back until it snaps in place.
Make sure the probe tip
and lens are clean and a
new, clean lens filter is
attached. Make sure
the thermometer is
properly inserted into
the ear. Then, take a
new temperature
measurement.
Wait 1 minute until the
thermometer turns off
automatically, then turn
on again.
... reset the thermo-
meter by removing the
battery and putting it
back in.
... call Kaz Customer
Service at
1-800-327-7226
Insert new battery.
Insert new battery.
Call Kaz Customer
Service.
®
alkaline

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

6026

Tabla de contenido