MoJack XT Instrucciones Para Asamblea Y De La Operación página 8

Operating Instructions
Using the MoJack XT (Steps 9 - 16)
STEP 9
Move Mower onto MoJack XT
The MoJack XT must be used on a solid
level surface.
• Drive or roll the mower onto the Wheel Pads.
Stop engine and remove the key.
STEP 10
Strapping Front Mower Tires to Wheel Pads
• Secure the front mower tires to the Wheel Pads using the Safety
Straps . Secure the hook on the Safety Strap to the Wheel Pad
10
Cross Bar and insert the Support Rod into the loop on the Safety
Strap by detaching the Support Rod and then sliding the Safety
Strap Loop through and reattaching the Support Rod.
• Tighten the Safety Straps over the top of the tires
to secure mower to Wheel Pads.
STEP 11
Adjusting the Crank Handle
(optional)
• The optimal Crank Handle length is in the longer setting. Some
mowers have brush guards or larger hoods that interfere with
the longer Crank Handle. The Crank Handle can be adjusted by
removing the Nylock Nut and Carriage Bolt and re-attaching in
the shorter setting.
Nylock Nut
Carriage Bolt
MoJack XT Lift
Safety Strap
Wheel Pad Cross Bar
Longer Setting – 8" Radius
Shorter Setting – 6" Radius
14
STEP 12
Raising the Mower
• Raise the mower by rotating the Crank Handle clockwise.
• See Step 22 for raising the mower with drill attachment.
Do not attempt to lift more than 500 lbs.
The MoJack XT must be used on a solid level surface.
The engine must be turned off and key removed.
The mower must be in neutral.
The parking brake must be off during this step.
The Safety Straps must be firmly tightened.
STEP 13
Raising Lift Arm to Locking Position
• Raise the Lift Arm until the Carrier Locking Pin drops into the
Safety Hole.
• The Carrier Locking Pin automatically drops into the Safety Holes as
the Carrier passes the Safety Holes on the Tower when raising.
• Note: When lowering the Lift Arm, the Carrier Locking Pin
must be held out by the operator until it clears the bottom
Support Rod
Safety Hole.
STEP 14
Preparing the Mower for Service
• Place wheel chocks (not included) behind the back tires of the mower.
• Now apply the parking brake on the mower.
• The Carrier Locking Pin must be locked into one of the two
Safety Holes.
MoJack XT Lift
Operating Instructions
Wheel Chock
15
Carrier
Locking
Pin
Pull Out
to
Unlock
and
Lower
Safety Hole