Placement And Mounting; Identifying The Parts; Main Unit - Saba JULY CI Manual De Instrucciones

Placement and mounting

Placement
• You are suggested putting the unit with below options:
Option - A
Stand Mounting should be Stand removal (if using option-B)
1� Remove the screws from the main unit�
GB
2� Drill 2 parallel holes (Ø 3-8 mm each
according to wall type) in the wall�
The distance between the holes should
be 121 mm�
wall
120
Option - B
3� Firmly fix 1 dowel into each hole in the wall
if necessary�
Dowel
Drywall, Plaster wall, Lath wall, etc�
Solid wall (i�e�, Solid brick,
Solid concrete, Solid wood,
Solid wooden battens)
4� Leave a 5mm gap between the wall and the
screw's head� Lift the unit with the attached
wall brackets over the heads of the screws
and slot into place�
5 mm
34 mm
The wall where the unit is to be installed must be capable of long-term support of the total load of
the unit� Measurements should also be taken to ensure sufficient strength to withstand the force of
earthquakes, vibrations and other external forces� Incorrect installation can cause the unit to fall and
cause injury�

Identifying the parts

Main Unit

1 2 3 4 5 6 7
8
9
10 11 12
12
1.
– Switch the unit between ON and Standby
mode�
2.
– Select a play function�
3.
– Open and close the disc compartment�
4.
– In CD/USB/Bluetooth mode, skip to previous
audio track�
– In CD/USB mode, press and hold the button
to search backward within a track/disc�
– In FM mode, search radio stations manually,
press and hold the button to search automatically�
17
13 16
14 15
5.
– Play/pause/resume playback�
– Press and hold to activate the pairing
function in Bluetooth mode and disconnect
the existing paired Bluetooth device�
– Confirm a selection�
6.
– In CD/USB/Bluetooth mode, skip to next
audio track�
– In CD/USB mode, press and hold the button
to search forward within a track/disc�
– In FM mode, search radio stations manually,
press and hold the button to search
automatically�
GB
121