RS HSH-1300 Manual De Instrucciones página 12

MANUAL REVERSE/AUTO REVERSE FUNCTION
1. Manual reverse function
During lamination, if the material is tilted towards one side, press "reverse" button to pull out the film.
2. Auto reverse function
If a jam occurs, the motor will automatically reverse until the pouch exits the front of the machine.
After removing the pouch from the front, the user can re-start lamination.
AUTO STAND-BY MODE AND POWER-OFF MODE
1. Auto stand-by mode
Stand-by mode: If no activity is made within 1 hour after each use, the machine will automatically switch into stand-by
mode. (Sets temperature to 80°C(176°F) speed 2)
2. Auto power-off mode
Auto power-off mode: If no activity is made for 30 minutes at Stand-by mode, the machine will automatically power
off.
If any activity is made while in stand-by or auto power-off mode the machine will return to it's previous stage.
NOTE:
To change to stand-by mode, press "ST/BY" button. (when in stand-by mode, temperature will automatically reset to
80°C(176°F) and all the buttons on the control panel are disabled) Press "ST/BY" mode button to resume normal
operation.
12