Hot Laminating Procedure - RS HSH-1300 Manual De Instrucciones

HOT LAMINATING PROCEDURE

1. Place and use the laminator on a sturdy, flat work surface.
2. Plug in the laminator after verifying the correct outlet voltage.
3. Press the power button.
4. Make sure the machine is in the HOT lamination mode by pressing the HOT/COLD button.
5. Select the correct pouch thickness by pressing the
6. Set the temperature and speed according to the pouch thickness. Please refer to the SPECIFICATIONS section for
recommended settings
7. The symbol will appear and you will hear 3 beeps when your desired temperature is met. The machine is now
ready for lamination.
8. Place the item to be laminated into the laminating pouch.
9. Insert the pouch (sealed side first) into the front opening of the machine.
10. The laminated item will exit out the rear of the machine when completed.
11. If you laminate several items continuously the
continuing lamination.
12. When the machine is on for an extended period of time, use a slightly lower temperature setting as the internal
temperature of the machine may actually be higher than the preset temperature, which may cause the document to
bend.
13. When you are finished laminating, press the OFF button. The cooling fan might continue to run and the rollers will
continue to roll until the temperature decreases to 60°C (140°F).
NOTE: • Your laminated item will be hot and can easily bend. To keep your laminated item flat, place on a flat surface
and allow to cool.
• When laminating material does not drop off completely from back of the machine, please gently pull out the material
• Do not use films smaller than name card sizes (65mm×95mm / 2.56"×3.7")
SET button.
may disappear, please wait until it is displayed again before
9
HSH-1300