Philips SalonStraight Ceramic HP4642/00 Manual Del Usaurio página 10

4222 002 62401
2 Set the the on/off switch to I.
The power-on light goes on.
The plates heat up rapidly and will be ready for use within seconds.
Never leave the appliance unattended when it is plugged in. Never
put the appliance on a surface that is not heat-resistant when it is
heating up and when it is hot.
3 Select the preferred temperature setting by turning the
adjustment knob to the preferred position (1 to 25) (fig. 2).
4 Comb or brush your hair so that it is disentangled and smooth
(fig. 3).
Use a comb to divide the hair into sections. Do not put too much hair
in one section.
Tip: it is better to section off the crown area and to straighten the hair
B
underneath first.Then straighten the top area.
5 Take a section that is approximately 3-4 cm wide. Place it
between the straightening plates and press the handles of the
appliance firmly together.
6 Slide the straightener down the length of the hair in a few
seconds, from root to hair end, without stopping to prevent
overheating (fig. 4).
7 Repeat this process after 20 seconds until you have achieved the
desired look.
8 Allow your hair to cool down. Do not comb or brush it before it
has cooled down, as this would ruin the hairstyle you have just
created.
Cleaning
1 Make sure the appliance is switched off and unplugged.
2 Let the appliance cool down completely on a heat-resistant
surface.
3 Clean the appliance with a damp cloth.
19-10-2005 15:33 Pagina 9 (Zwart/Process Black
ENGLISH 9