Glacier bay VWD5446BLS Guía De Uso Y Cuidado página 7

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Pre-Operation (continued)
ANTI-lEAK bOTTlE SUPPORT cOllAR
The bottle support collar (A) on your water dispenser is engineered with a
special anti-leak-proof system to prevent accidental loss of water, (flooding)
as a result of inadvertently installing a defective water bottle. Unfortunately,
not all water bottles are created equal. Almost all 3 and 5 gallon (12 and
19 L) water bottles are recycled and handled extensively during cleaning,
filling, and shipping. As a result, they are very prone to developing hairline
fractures and pinhole leaks that are not always obvious to the end user until
the time of installation.
iMPOrTanT: Never knowingly install a defective water bottle on a
water dispenser. Return immediately for replacement.
If you are experiencing a leak, this simple test will allow you to determine
whether your water bottle or dispenser is the source of the problem.
□ Unplug the unit and remove the water bottle.
□ Remove the bottle support collar (A) and check the water level inside
the reservoir. It should be roughly three quarters full.
□ Add or drain a few glasses of water to achieve the required fill level.
□ Closely monitor the water level inside the reservoir (1-2 hours). If the
water level drops, immediately drain the remaining water from the unit
and call customer service at 1-877-527-0313. If the water level remains
constant, it is the water bottle and not the dispenser that is leaking.
Please contact your water supplier for a replacement bottle.
READY-TO-DISPENSE INDIcATOR lIGHTS
red
BLUe
YeLLOW
FLASHING
The heater (hot water tank) is operational.
STEADY ON
The hot water has reached optimum temperature and is ready for dispensing.
The hot water tank is off, however remaining water within the tank may still be
OFF
very hot. Always exercise caution when dispensing and/or draining water from
the hot water tank.
STEADY ON
The cold water has reached optimum temperature and is ready for dispensing.
The cooling cycle is in progress. It is possible to dispense water during the
OFF
cooling cycle; however, optimum cooling temperature may not yet be achieved.
FLASHING
The water level inside the internal reservoir is low. The water bottle is empty.
OFF
The status of all water levels are normal.
A
7
Please contact 1-877-527-0313 for further assistance.
Vent Tube
Water Level
HOMEDEPOT.COM

Publicidad

Capítulos

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

236-758

Tabla de contenido