Program The Esc - Carson Brushless Speed Controller Dragster 6S Manual De Instrucciones

f. Program the ESC
1. Programmable items
(the italics texts in the form are the default settings)
Programmable items for Dragster S6
Programmable
item
1. Running mode Forward
with brake
2. Drag brake force
in neutral
position
3. Low voltage Non-
cut-off threshold protection
4. Start mode Level
(punch)
5. Maximal
brake force
2. Explanation for each
programmable item
Running mode
With "Forward with Brake" mode, the car can go
forward and brake, but cannot go backward, this
mode is suitable for competition.
"Forward/reverse with brake" mode provides
backward function, which is suitable for daily
training.
But for ESC, "Forward/reverse with brake" mode
uses the "Single-click" method to make the car go
backward.
"Forward/reverse" mode uses the "Single-click"
method to make the car go backward. When you
move the throttle lever from forward zone to back-
ward zone, the car will go backward immediately.
1 2
Forward/ Forward/
backward backward
with brake
0% 5%
2.6 V/ 2.8 V/
cell
Level Level
1 2
25% 50% 75%
CARSON Brushless Speed Controller Dragster 6S
Programmable
value
3 4 5
10% 20% 40%
3.0 V/ 3.2 V/
cell cell cell
Level Level
3 4 5
100% deacti-
vated
Drag brake force in neutral
position (throttle)
Set the amount of drag brake applied at neutral
throttle to simulate the slight braking effect of a
neutral brushed motor while idle speed.
2.1. Low voltage cut-off
The function prevents the lithium battery pack from
over discharging. The ESC detects the battery's
voltage at any time. If the voltage is lower than the
threshold for 2 seconds, the output power will be
reduced 70%, 10 seconds later the output will be
completely stopped, and the red LED flashes in
such a style: "✼ ✼, ✼ ✼, ✼ ✼" (double flashes).
2.2. Acceleration mode
(also called "Punch")
Select from "Level 1" to "Level 9". A higher number
means more aggressive acceleration.
6 7 8
60% 80% 100%
3.4 V/
cell
Level Level Level Level
6 7 8
GB
9
9
25