Synchronising The Controller With The Remote Transmitter - Carson DRAGSTER SPORT BRUSHLESS SENSORLESS Instrucciones

2. Synchronising the controller with the
• Switch on the transmitter.
• Connect the controller to the power supply.
• Hold down the SET button and switch the controller on at the
on / off switch; you will hear a beep.
The blue LED lights up.
GB
• Set the throttle / brake lever to the full acceleration position.
The red and yellow LED lamps fl ash briefl y and then remain
illuminated. You will hear a beep.
The full throttle setting is stored.
• Return the throttle / brake lever fully.
The yellow and blue LED lamps fl ash briefl y and then remain
illuminated. You will hear two beeps.
The brake setting is stored.
• Put the throttle / brake lever to neutral.
The red and green LED lamps fl ash briefl y and then remain
illuminated. You will hear three beeps.
• The synchronization is complete, all LEDs are out.
• Switch the controller off.
When you switch the controller on again, the speed controller is
synchronized to the transmitter and is fundamentally ready for use.
8
011847_anl_906056_regler_drag_7k8 8 011847_anl_906056_regler_drag_7k8 8
remote transmitter
If your RC car goes backwards when you activate
the transmitter to accelerate forwards, swap 2 of 3 cables
CARSON DRAGSTER Brushless-Regler 906008+906056
to the motor.
04.03.2008 11:45:10 Uhr 04.03.2008 11:45:10 Uhr