Program The Esc With The Set Button - Carson Brushless Speed Controller Dragster 6S Manual De Instrucciones

3. Program the ESC with the
"SET" button
You'll find the instructions on the next page in the
flowchart.
GB
4. Reset all items to default
values
At any time when the throttle is located in
neutral zone (except in the throttle calibration
process or ESC program mode), you can hold the
"SET" key for over 3 seconds. The red LED and green
LED will flash at the same time, which means each
programmable item has be reset to its default
value.
g. Program the ESC with the Set Button
The following is a flowchart
sample for programming the
Dragster S6 controller.
26 CARSON Brushless Speed Controller Dragster 6S
Note:
In the program process, when the LED is flashing,
the motor will emit "Beep" tone at the same time.