Fax +1 305 430 9692
Condition 2: Tare function (when the load on scale is more than 0.2kg / 0.44
lb)
Proceed the same way as with the zero function. The display will show "0" or
"00:0.0" each time the "On/Zero" button is pressed. The icon "TARE" will
show on the left side of the display once the function is activated. The
maximum weight capacity for the next ingredient is reduced by the total
weight of the previous loads.
Note: When you remove the container from the platform, the LCD display
will show the weight as negative (" – " will appear on the left-hand side). To
reset, press "On/Zero" again.
ERROR INDICATION
If the display shows symbols randomly or if the scale doesn't turn off
automatically, it means that your scale has a problem (wrong initialization
or weighing error).
Remove any object from the scale and wait for it to turn off. Then start
again. If the problem persists, remove the battery for 10 seconds, and then
put it back in place.
OVERLOADING INDICATOR
If the "EEEE" symbol appears on the LCD screen, it means that the
maximum weight accepted by your scale is exceeded. Please remove the
object from the platform in order not to damage your scale.
Copies of the I/B. Please reproduce them without any
changes
except
under
International USA. The pages must be reproduced and folded
in order to obtain a booklet A5 (+/- 148.5 mm width x 210 mm
height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't change
the page numbering. Keep the language integrity.
what is inside the frame,
Zero
6
Assembly page 6/24
special
instruction
from
Team
Print only
Tare
EKS 42441/42442/42443 - 120501